Introducing a unique beltless low-profile conveyor for part and scrap handling -

THE CHUTER
.
THE CHUTER integrates with P/A Transporters for a low-maintenance part transporting and scrap sorting solution. Chuter and P/A Transporter

The Chuter: Typical Setup

The Chuter - typical setup

Recommended Methods of Supporting Chutes

(at end opposite the transporter) See also: Backside Support Systems

 
Note: Slight space between the bottom of the chute and the bolster is desirable to eliminate drag and wear on both surfaces. On longer chutes (over 72") some upward force actually enhances part movement by eliminating whip and ensuring alignment.

 
Chutes to 72" Chutes 73" to 120"

Nylon Washer

Nylon washer or spacer epoxied to
bottom of chute for support, clearance
and wear resistance (Customer Supplied).
Suitable for chutes up to about 72" long.

Nylon Washer
Backside Support System

Linear Slide Support with Magnet
PRI Part # CS-10, CS-40
CS-70 and CS-XL.
(Crossbar width over 72" requires CS-XL
with 2 "L" Brackets.)

Backside Supprt System

How to Order a Chuter System

1. Determine the number and size of chutes needed. Allow for desired overhang and required length under the die.
   
Select:    
  a. Length: _________
  b. Width: __________
  c. Quantity: _________
  d. Figure the total square inches for the system based on the three factors above: ________
2. Select the Transporter model which best fills your needs using the formula shown here and on the order form:
    TP-10 500 Sq. In. Max. Total of Chute surface area
TP-40 1500 Sq. In. Max. Total of Chute surface area
TP-70 3000 Sq. In. Max. Total of Chute surface area
3. Select the appropriate mounting bracket. OPTIONAL, however you will have four to five hours of fabrication time including hole alignment and drilling if you build your own. Ours range from $135.00 to $145.00 USD. (Huge Time Saver- Makes 60 Minute Installation Possible).
4. Assembly Kit - This is the heart of The Chuter System's innovative design. Order according to Transporter selected. (Carriage bolt in miniature "T" slot of crossbar does the trick).
5. Chutes - The embossed 304 Stainless Steel (22 gauge) material we use increases product flow up to five times better than flat steel. Also breaks "wet stick with oily parts." We build any length, width, sidewall configuration (1" is standard and recommended), and special configurations such as angles or doglegs. Customer can easily add baffles for singulation or diverters.
6. Backside Support Methods. See our Backside Supports page.
7. Entire systems including chutes generally ship within one week and often less.
8. Call Us Today To Get Something Movin' and Shakin'! 800-276-5467