Specifications Gemco 2110 Shut Height Monitor

• Power Requirements — 85 - 265 VAC
  50/60 Hz; Internally Fused at 1.5 Amps
• Temperature — Operating: 32° to
  131° F; Storage: 0° to 150° F
• Environmental — Humidity: 5% to
  95%; Non-condensing
• Shock & Vibration — Tested to: MILSTD
  810E, Method 514.4, Category 10,
  20 - 2K Hz, 2G sine, 0.04 G2/Hz random.
  To UL 491, SA 19, 10 - 150 Hz,
  10G sine.
• Electromagnetic Compatibility —
  Tested to: IEC 801-2, Level 5
  (Electrostatic discharge requirements);
  IEC 801-4, Level 4 (Electrical fast transient/
  burst requirements);IEC 801-5,
  Level 3,5 (Surge immunity requirements)
• Memory Retention Time — Maintains
  last programmed values for ten (10)
  years without power
• Relay Contact Ratings — All relays
  rated UL & CSA for 1⁄4 HP, 125 to 250
  VAC; 8A 250 VAC, 30 VDC, Shock
  Resistant to 10 G
• Movement Input — 85 - 265 VAC, 12
  mA (rms) maximum; optical isolated to
  3200 VDC/2250 VAC
• Program Mode Key Input — Dry
  Contact; Open Collector (drain) ONLY;
  +5 VDC maximum — Current 0.2 mA
• RS - 232 Output — 115.2 K baud
• RS - 485 Output — 115.2 K baud

Software Specifications:

• Four (4) Programming Keys
• Software-Controlled Upper and Lower Limits
• Programmable Bolster Offset
• Programmable Zero Offset
• Programmable Movement Detection
• Programmable Wire Speed (LDT Modules)
• Programmable Count Direction (LDT Modules)
• Programmable Scale Factor (Resolver Module)
• Programmable Negative Overshoot
• Programmable Position “Hold”
• Read Out in Inches or Millimeters